AUTHENTIC
Primary Weapons Systems
Barrel Comps Alignment System
“Timing” “Clocking” Kit
(1 set) 223/556 with 1/2×28 TPI
or
(1 set) 308/300blk with 5/8×24 TPI
Perfect for trying to align your comp correctly like the Strike Industries Cookie Cutter on custom builds and many others.
This PWS shim kit is a replacement for the peel washer and is used for mounting Comps.
New barrel comps normally supplied with the necessary washers, nuts, or shims; however sometimes replacement washers are needed if one is damaged or if installing a barrel comp on a different gun. While Peel washers require you to heat them and then peel off separate layers of the washer to get to the desire thickness, a Shim Kit is much simpler. There is no heating or peeling of layers needed. Just install the necessary combination of shims to get the precise alignment you need.
223/556 1/2×28 TPI
QTY 1 of Shim 1 (largest)QTY 8 of Shim 2 (medium) QTY 1 of Shim 3 (smallest)
or
308/300 BLK 5/8×24 TPI
QTY 1 of Shim 1 (largest)QTY 8 of Shim 2 (medium)QTY 1 of Shim 3 (smallest)
The large shim can be used to give the installer one half of a rotation or as a spacer for barrels that do not have relief cuts behind the threads. Shim 2 is used in varying quantities to achieve the proper alignment of your barrel device. This shim gives the installer approximately 45 degrees of rotation. If needed, Shim 3 can be used where smaller degrees of rotation are needed for proper alignment.
Specifications
Hardened steel shims ensure precise fit and correct alignment of barrel comps