The Strike Industries Angled Vertical Grip with Cable Management is engineered like no other grip on the market. The grip angle sits on the handguard at 86 degrees. Patent pending SI cable management function enables you to organize and store excess wire from your weapon light or any other cabled accessories in multiple configurations. Instead of tucking wire anywhere you can and using cable ties or tape to hold it down, the cable management feature will offer you a place to route and/or contain loose wire inside the grip cavity. The side cuts at the top middle of the grip allow for easier pressure switch attachment. Compared to the Short version, the Long version has an added built-in stability feature when you place the L-shaped bottom onto a table edge/corner or as a barricade stop, giving you another way to get back on target faster downrange. The Short version can be mounted in either direction for your own preferred and personal setup and is low-profile form helps to minimize snags. The forward angle provides more of a natural wrist angle and increased rigidity of forearm. Designed with textured palm and finger areas with flat sides for positive handling and easier manipulation of the firearm. Made from durable and lightweight polymer compatible with M-LOK rails, the Strike Industries Angled Vertical Grip with Cable Management No messy wires.
-x1 Angled Vertical Short Grip
-x2 #8-32×0.3″ screw
-x2 M-LOK nut
-x1 Torx key
-x1 Loctite® Threadlocker Blue 242®
-86° grip angle
-Built-in cable management w/ excess wire storage (patent pending)
-Forward angle provides more of a natural wrist angle and increased rigidity of forearm
-Side cuts at top of grip for pressure switch cable routing
-Low-profile design to minimize snags (Short)
-Can be mounted in either direction for preferred setup (Short)
-Textured palm and finger areas with flat sides for better weapon manipulation control
-Made from durable and lightweight polymer
-For M-LOK rails
-Always check with your state and local laws. We are not lawyers.
-LINK screws and nuts provided are not manufacturer by Strike Industries. Please make routine checks that the screws and nuts are secure as part of the preventive maintenance of the firearm.
You will receive the FDE version. Some pictures show black for illustration only.